CMI Figure 8 Belay & Rappel Device

CMI FIGURE "8"

Dusty, dirty or muddy ropes in your future? Get extra wear and value from CMI's Hard Coat anodized finish. Can be used as a belay plate by threading a bight of rope through the small hole and clipping to your harness's belay loop with a locking biner. Be sure to clip the big end with a quick draw to to keep your 8 RING close in hand. Will accommodate a wide range of rope diameters from 8-12 mm. NFPA approved.
wt: 115 gm 4.2 oz	strength: 10,000 lbf / 44 kN
color: gray (not red)	price: $33.45

FIGURE 8's are great for rappelling and handling belay chores. Knots can be passed easily, multiple rigging options vary friction and greater mass dissapates more heat.

Back to Descenders & Solo Belay

ATTENTION: CALIFORNIA PROPOSITION 65
Click the following link for products that contain one or more chemicals known to the State of California
to cause cancer and/or birth defects or other reproductive harm. www.p65warnings.ca.gov
[ CLIMBING IS DANGEROUS ] [ORDERING INFO & RETURNS POLICY ]